Dev Blog
| ./dev |
|
Original theme by orderedlist (CC-BY-SA)
Where applicable, all content is licensed under a CC-BY-SA.
|
Common GCode Commands
| GCode | Description |
|---|---|
G0 |
Rapid motion |
G1 |
Slow motion |
G20 |
Units in inches |
G21 |
Units in mm |
G38.2 |
Probe towards workspace (-), stop on contact, alarm if probe not tripped |
G38.3 |
Probe towards workspace (-), stop on contact |
G38.4 |
Probe away from workspace (+), stop on loss of contact, alarm if probe not tripped |
G38.5 |
Probe away from workspace (+), stop on loss of contact |
M3[S<S>] |
Start spindle |
M5 |
Stop spindle |